ACR Electronics PLB-350B Especificaciones

Y1-03-0241C i

Y1-03-0241C 9 NOTE: The appearance of your key pad may vary from this picture. Figure 2 - Key Pad Functions NOTE: If you notice the

Y1-03-0241C 10 6. Activation (406 MHz and 121.5 MHz) To activate your beacon in a distress situation, follow these steps (see Figure 3 below). 1)

Y1-03-0241C 11 Figure 4 – GPS Receiver Location will stop blinking and the red LED will flash once every 2 seconds until new GPS data is obtained.

Y1-03-0241C 12 11. Preventing false alerts A false alert is any activation of the beacon, intentional or otherwise, that does not result from a situ

Y1-03-0241C 13 To report false alerts outside of the USA, contact the national authority where your beacon is registered. STEP THREE - MA

Y1-03-0241C 14 batteries contained in this equipment to make sure they properly label your package. Call ACR’s Technical Service department a

Y1-03-0241C 15 4. Battery witness seal failure If your beacon flashes an initial red LED at the beginning of the Self-test, this indicates that you

Y1-03-0241C 16 6. Changing ownership or contact information As the owner of the beacon, it is your responsibility to advise the national authority

Y1-03-0241C 17 Figure 5 - Belt Clip APPENDIX A - ACCESSORIES 1. Multi-Function Belt Clip The SARLink™ comes standard with a multi-function be

Y1-03-0241C 18 Figure 6 – Attachment Clip 2. Attachment Clip The AquaLink™ comes standard with an attachment clip. To install the clip, simply

Y1-03-0241C 1 CAUTION: Before proceeding to install, test or use your new ACR Electronics’ product, please read this Product Support Manual in

Y1-03-0241C 19 APPENDIX B - THE COSPAS-SARSAT SYSTEM 1. General overview Beacons transmit to the satellite portion of the Cospas-Sarsat system. Cos

Y1-03-0241C 20 APPENDIX C - TECHNICAL SPECIFICATIONS 406 MHz Transmitter Frequency 406 MHz Output Power greater than 5 watts (typical: 6.3 watts) Fr

Y1-03-0241C 21 APPENDIX D - WARRANTY, USEFUL LIFE POLICY, NOTICES Limited Warranty This product is warranted against factory defects in material and

Y1-03-0241C 22 EC DECLARATION OF CONFORMITY ACR Electronics, Inc. hereby declares that the following products are in conformity with D

Y1-03-0241C 2 Table of Contents STEP ONE - REGISTERING YOUR BEACON _____________________ 3 STEP TWO - HOW THE BEACON WORKS _____________________

Y1-03-0241C 3 STEP ONE - REGISTERING YOUR BEACON Why is registration important? As the owner of this 406 MHz beacon, it is mandatory that you regis

Y1-03-0241C 4 What country should I register in? The beacon must be registered in the country of the owner’s residence. If the beacon is not pr

Y1-03-0241C 5 Registration in Canada Canadian residents can register online at: http://canadianbeaconregistry.forces.gc.ca/ or contact the Canadia

Y1-03-0241C 6 The 406 MHz signal is detected by multiple satellites and from that information the location of the beacon can be c

Y1-03-0241C 7 3. Anatomy of your beacon NOTE: The appearance of your beacon may vary from this picture. Figure 1 Antenna Latch FRONT

Y1-03-0241C 8 4. Distinguishing PLB Features The distinguishing features available on your PLB vary with the particular model that you sel