ACR Electronics Nauticast Y1-03-0212 Manual de instalación Pagina 53

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 94
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 52
Installation Manual 49 Y1-03-0212 Rev. E
56
AIS: ENTER MMSI NUMBER
No valid MMSI
entered.
Reaction: During the initial boot or after “factory settings” the user is
asked to enter a valid MMSI. As long as this is not done, the system
does not transmit.
Remedy: Enter a valid MMSI
5.3 Text Messages
ID
Description Text
Cause/Source
Reaction of the System / Remedy
07
AIS: UTC clock lost
Internal GPS
Reaction: the transponder unit continues operation using indirect or
semaphore synchronisation
Remedy:
Check GPS Antenna for AIS.
21
AIS: external DGNSS in use
Information
Reaction: Positioning is fully operational
Remedy: no action required
22
AIS: external GNSS in use
Information
Reaction: The transponder unit continues operation using the position
data from a GNSS receiver
Remedy: no action required
23
AIS: internal DGNSS in use
(beacon) 023
Information
Reaction: The transponder unit uses position data from the internal
source. The internal GNSS receiver is capable of processing DGNSS
corrections.
Remedy: no action required
24
AIS: internal DGNSS in use
(message 17)
25
AIS: internal GNSS in use
Information
additional to
Alarm ID 25
Reaction: The transponder unit continues operation using the position
data from the internal GPS.
Remedy
Check the sensor and the cabling; Check if the system that delivers the
data is working; Check the baud rate settings of the sensor input
27
AIS: external SOG/COG in use
Information
Reaction: COG/SOG is in full operation
Remedy: no action required
28
AIS: internal SOG/COG in use
Information
additional to
Alarm ID 29 or
ID 30
Reaction: The transponder unit continues operation using the data from
the internal GPS.
Remedy:
Check the sensor and the cabling; Check if the system that delivers the
data is working; Check the baud rate settings of the sensor inputs
31
AIS: Heading valid
Information
Reaction: Heading is in full operation
Remedy: no action required
33
AIS: Rate of Turn Indicator in
use
Information
Reaction: A Rate Of Turn indicator is connected and in full operation
Remedy: no action required
34
AIS: Other ROT source in use
Information
Reaction: The transponder unit is operating with ROT data rather than
with TIROT data - therefore the AIS only differs between
+ 127 (turning right at 720 degrees per minute or higher) and
127 (turning left at 720 degrees per minute or higher)
5.4 Restarting the NAUTICAST
The NAUTICAST can be restarted during operation by pressing the keys “Shift” + “Fn” + “Del”
simultaneously. It may take up to 6 minutes to receive all information from other ships again
because of their reporting interval.
Vista de pagina 52
1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 93 94

Comentarios a estos manuales

Sin comentarios