ACR Electronics RCL 100 Especificaciones

Y1-03-0158G 9 Figure 7 Remove the deck mounting plate from the light base (4 Allen bolts). Save the bolts and washers. Lo

Y1-03-0158G 10 Seat the light assembly on the deck mount. Make sure the key is mated and the gasket edge is not pinched. Reinstall the four (4 ) st

Y1-03-0158G 11 Remove the light from its mounting location. Lamps should be changed in an environment that includes good lighting and prot

Y1-03-0158G 12 Figure 14 Figure 15 6) At the point where the grey bulb wire passes through the partition wall, remove the sealant wit

Y1-03-0158G 13 12) Install new bulb, aligning the larger hole toward the back of the tube with the G-clip hole. Do not touch bulb with b

Y1-03-0158G 14 Figure 18 Figure 19 block and screw tightened securely. Gather wires together and install new cable ties (see Figure 19). 21) Repla

Y1-03-0158G 15 APPENDIX A - SPECIFICATIONS NOTE: Specifications are for the RCL-75 with remote control Point Pad™ RCL-75 Specifications Power re

Y1-03-0158G 16 APPENDIX B - ACCESSORIES The following are options and replacement parts that can be ordered for your searchlight: Item Product Num

Y1-03-0158G 17 Figure 21-Installation with extension cable harness Figure 22-Installation with second Point Pad™ station

Y1-03-0158G 18 APPENDIX D - WARRANTY, USEFUL LIFE POLICY, NOTICES Limited Warranty This product is warranted against factory defects in material a

CAUTION: Before proceeding to install, test or use your new ACR Electronics’ product, please read this Product Support Manual in its entir

Y1-03-0158G 19 EC DECLARATION OF CONFORMITY ACR Electronics, Inc. hereby declares that the following product is in conformity with Directive

Y1-03-0158G 2 Table of Contents SECTION 1 - HOW THE SEARCHLIGHT WORKS _________________ 3 SECTION 2 - PREPARING TO INSTALL ___________________

Y1-03-0158G 3 SECTION 1 - HOW THE SEARCHLIGHT WORKS The RCL-75 was specially designed for mariners who require a high intensity remote co

Y1-03-0158G 4 981-3333. Please be ready to provide the serial number of your unit and location of purchase. Figure 1

Y1-03-0158G 5 Tools and fasteners needed for installation The following tools and marine-grade fasteners are needed for installation but are not i

Y1-03-0158G 6 bulkhead, use a cable outlet (available at marine hardware stores). Wire should be supported where necessary by the use of cable stra

Y1-03-0158G 7 CAUTION: The connectors on each side of the wire harness are different. Test fit connector to switch before running the harness to th

Y1-03-0158G 8 When the flush mount option is selected, cut a rectangular hole in the dashboard location using the Point Pad™ Flush Mount Te