ACR Electronics SmartReader Plus Manual de usuario descargar pdf (Pagina 25)

SmartReader Data Logger

notes packed with each RH probe set -- see Figure 2-2.

Figure 2-2: Connecting the EH-020A Temperature and RH Probe

The EH-020A is applicable for measurements between -20 and 40°C (-4 and 104°F) and 10 to

90% RH.

NOTE: The EH-020A probe is compatible with loggers that have serial numbers

above 20,000 only.

The accurate measurement of temperature and humidity depends primarily on the information

supplied by a particular sensor. SmartReader 2 data loggers use temperature and humidity

sensors with rugged qualities designed for minimal or no maintenance (under normal

operating conditions).

The SmartReader 2's on-board thermistor is chemically stable and not significantly affected by

aging. It will typically drift less than 0.1°C over a period of several years. The relative humidity

sensor, although subject to accuracy degradation when exposed to contaminants and/or

extreme environmental conditions, will drift typically less than 1% per year (under clean

conditions). You should check your RH sensor periodically and, if necessary, recalibrate or

replace it.

1.4.4 Troubleshooting

If you are getting what appear to be wrong readings, consider the following before recalibrating

the sensors. Sensors sample the atmosphere (or medium) only in the immediate vicinity of

the sensors themselves. The physical state of the atmosphere and its degree of uniformity

and turbulence will limit the validity of a measurement at some distance from the sensor. This

becomes especially apparent for the measurement of ambient temperature and relative

humidity.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 102 103

Sin comentarios

ACR Electronics SmartReader Plus Manual de usuario Pagina 25