
SmartReader Data Logger
25
Copyright © 2010 ACR Systems Inc. All Rights Reserved.
Figure 4-2: SmartReader 4 Accessories
1.6.2 Setup
Using the Pressure Modules
1. If you are going to measure pressure, you will need a Pressure Module, a length of plastic
tubing and the appropriate fittings to tie into the system or equipment you intend to
monitor.
2. To connect the Pressure Module, plug it into the five terminals as shown in Figure 4-2.
Make sure it is properly plugged in and secured to the terminal block.
3. Use TrendReader software to enable the pressure channel. Then assign the correct
pressure equation for the model of Pressure Module you are using. If you want to switch
from one Pressure Module to another, change the equation number assigned to the
pressure channel.
Comentarios a estos manuales